Avaya C360 manual Router can be configured to operate either

	IP Route
Table 20-8.	RIP Interface Parameters (Continued)
Field	Description
RIP Version	The router can be configured to operate either
	RIP version 1 or RIP version 2 on each IP
	interface. The configuration of the RIP version
	must be consistent on each subnet. That is, all
	routers should be configured with the same RIP
	version on their interface to the subnet.
	When possible, homogeneous configuration of
	the RIP version in the network is
	recommended.
	• Rip1 - The router runs regular RIP on that
	interface, following the RIP version 1
	subnet aggregation rules. That is, it
	advertises an aggregate route for the net as
	opposed to advertising subnet routes across
	the network boundary.
	• Rip2 - The router runs RIP version 2 on
	that interface. RIP version 2
	advertisements are sent as multicast rather
	than broadcast. No route aggregation is
	done in RIP version 2. RIP version 2 allows
	for Variable Length Subnets Masks
	(VLSM), meaning that subnets of the same
	net may have masks of different lengths,
	and may be of different sizes.
Send Receive Mode	What the device sends on this interface. Values
	are:
	• talk-listen- RIP updates contain the entire
	routing table.
	• talkDefault-listen- RIP updates contain
	only a single entry. This advertises the
	router as the default router.
	• listen-only- No RIP updates are sent.
Cost	The cost of using this interface. RIP chooses the
	route with the lowest total cost (metric) for
	each destination.
Default Route Metric	The metric of the default route entry in RIP
	updates originated on this interface, if
	configured to SendDefaultOnly.

Avaya C360 Manager User Guide 237