B&K 8510 instruction manual Setting / Reading CC mode current value（2AH/2BH）

7. Setting / Reading CC mode current value（2AH/2BH）

1st byte	Start bit ( AAH )
2nd byte	Address (0—0XFE)
3rd byte	Command （2AH/2BH）
4th byte	The lowest byte of current value
5th byte	The lower byte of current value.
6th byte	The higher byte of current value.
7th byte	The highest byte of current value.
From 8th To 25th byte	System reserve
27th byte	Sum code

NOTE

Represent current by 4 bytes of Hex. Lower bytes are in the front location, higher bytes are in the later location. For example: current is 3.0000A，Hex code is 0X00007530，NO. 4 bye is 0X30，NO. 5 bye is 0X75，NO. 6 bye is 0X00， NO. 7 bye is 0X00。

8. Setting / Reading CV mode voltage value.（2CH/2DH）

1st byte	Start bit ( AAH )
2nd byte	Address (0—0XFE)
3rd byte	Command（2CH/2DH）
4th byte	The lowest byte of voltage value.
5th byte	The lower byte of voltage value.
6th byte	The higher byte of voltage value.
7th byte	The highest byte of voltage value.
From 8th to 25th byte	System reserve
26th byte	Sum code

NOTE

Represent voltage by 4 bytes of Hex. Lower bytes are in the front location, higher bytes are in the later location. For example :voltage is 16.000V，Hex code is 0X00003EB0，4th byte 0XB0，5TH byte is 0X3E，6th byte is 0X00，7th bytes

0X00。

9. Setting / Reading CW mode watt value（2EH/2FH）

1st byte

2nd byte

3rd byte

4th byte

5th byte

6th byte

Start bit ( AAH )

Address (0—0XFE)

Command（2EH/2FH）

The lowest byte of max power value

The lower byte of max power value

The higher byte of max power value

42