B&K 8510 instruction manual Front Panel Operation, Case of Trouble, Front Panel Display

6.Press △▽

0.000W I: 0.000A

Display the actual power value and setting value.

In Case of Trouble

Should the power-on self test of the Electronic Load fail, you may try the following: When turning on the power, make sure the power cord to the unit is plugged in and the power switch is in the on position.

1)Check the power voltage setting.

Work voltage of load have two type 110V or 220V , Please make sure it is right voltage accordance to the voltage in your area. You could change the voltage setting through dial the switch in the rear panel.

2)Check the fuse.

If fuse is blown, please replace it according to the following specification.

Model	Fuse specification		Fuse specification
	(110VAC)		(220VAC)
8510	T0.5A	250V	T0.3A	250V

3) Location of Fuse

Fuse

Front Panel Operation

Display

16-character fluorescent display for showing measurements and programmed values.

Front Panel Display

Indicators for operating modes and status conditions:

OFF	power off	Trigger	Indicates that the electronic load is waiting an
			initiate and trigger to occur.
CC	The selected input channel is in the	Sense	Indicates that the electronic load is in sense
	constant current (CC) mode.		state
CV	The selected input channel is in the	Error	A errors have occurred
	constant voltage (CV) mode.
CW	The selected input channel is in the	Link	In the communication state
	constant power (CW) mode.

25