Baldor MIN1853 Extend more than 0.2 5 into keypad assembly, Vapors, metal particles and dust

Caution:	To prevent keypad damage, be sure keypad mounting screws do not
	extend more than 0.2 (5) into keypad assembly.
Caution:	Avoid locating the control in the vicinity of corrosive substances or
	vapors, metal particles and dust.
Caution:	Baldor recommends not using “Grounded Leg Delta” transformer power
	leads that may create ground loops and degrade system performance.
	Instead, we recommend using a four wire Wye.
Caution:	Logic signals are interruptible signals; these signals are removed when
	power is removed from the drive.
Caution:	The safe integration of the driver into a machine system is the
	responsibility of the machine designer. Be sure to comply with the local
	safety requirements at the place where the machine is to be used. In
	Europe this is the Machinery Directive, the ElectroMagnetic Compatibility
	Directive and the Low Voltage Directive. In the United States this is the
	National Electrical code and local codes.
Caution:	Drivers must be installed inside an electrical cabinet that provides
	environmental control and protection. Installation information for the drive
	is provided in this manual. Motors and controlling devices that connect to
	the driver should have specifications compatible to the drive.
Caution:	Do not tin (solder) exposed wires. Solder contracts over time and may
	cause loose connections.
Caution:	Electrical components can be damaged by static electricity. Use ESD
	(electro-static discharge) procedures when handling this control.
Caution:	Do not connect or disconnect motor wires from the control while power is
	on. If motor leads are disconnected while the control is powered up,
	damage to the control may result.

1-4General Information MN1853