Black Box LRU4240 E1 framing, E1 line-impedance, E1 timeslot, Interface Ifname icmp-redirect

Dual Trunk E1 Router

There are no arguments or keywords for this command.

Examples

Unit(enable)#show unit id 19: unit id SUNN1

e1 framing

Use the e1 framing command to configure the network E1 framing format.

Command Syntax: e1 framing [net1 net2 aux] [unstructured crc-enabled crc-disabled]

Command Mode: Config

Example

unit(config)#e1 framing net1 unstructured unit(config)#

e1 line-impedance

Use the e1 line-impedancecommand to configure the network port line impedance to 75 or 120 ohms. This command is reserved

for BlackBox personnel only, as it requires changing jumper settings on the hardware unit.
Command Syntax: e1 line-impedance [net1 net2 aux] [120-ohm 75-ohm]
[net1 net2 aux] select the network port
120-ohm		set line impedance to 120 ohm
75-ohm		set line impedance to 75 ohm
Command Mode: Config
Example
unit(config)#e1 line-impedance net1 120-ohm
e1 timeslot
Use the e1 timeslot command to allocate an E1 timeslot and assign it to data, voice or idle.
Command Syntax: e1 timeslot <1-31> [aux f1 idle]
<1-31> select an E1 timeslot number
aux	Assign selected timeslot to auxiliary dro-and-insert port
f1	Assign selected timeslot to Ethernet data port
idle	Selected timeslot will not be used
Command Mode: Config
Example
Assign timeslot 10 to transport data from Ethernet data port.
unit(config)#e1 timeslot 10 f1
interface IFNAME icmp-redirect
Use the interface IFNAME icmp-redirectcommand to enable or disable ICMP redirect messages on the named interface
Command Syntax: interface [enet net1 net2 bundle0] icmp-redirect [disabled enabled]
disabled		Do not send ICMP redirect messages on this interface
enabled		Send ICMP redirect messages on this interface
Usage
ICMP redirect should be configured on the Ethernet interface only.
Command Mode: Config
interface IFNAME ip-addr
Use the interface IFNAME ip-addrcommand to set the interface IP address and subnet mask
Command Syntax: interface [enet net1 net2 bundle0 comm] ip-addr <A.B.C.D>/<Len>
enet	Ethernet port
net1	Network port 1
net2	Network port 2

comm COMM port

bundle0 multilink interface, in multilink mode

Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 143