Black Box LRU4240 manual Parameter Parameter-Options Definition

			Dual Trunk E1 Router
	Table D-1 Router Menus (5 of 5)
Menu
Number	Name		Description	Page
$IA	Static Frame Relay Map		Configure manually DLCI to IP address mappings. See “Configuring Frame
	config		Relay DLCIs” on page 33
$IB	Display active Frame Relay		View current DLCI to IP address mappings. If inverse ARP is enabled on an
	Map Table		interface, DLCI to IP address mappings is automatically learnt.
			Manually configured mappings are also displayed on this menu.
$JA	NAP/NAPT configuration -		Configure global IP addresses and mapping to network interfaces. See
	Global Map table		“Configuring NAT” on page 54
$JB	NAP/NAPT configuration -		Assign manually global IP addresses to local hosts. See “Configuring NAT”
	Static table		on page 54
$JC	NAP/NAPT configuration -		Configure local networks requiring NAT. “NAT Configuration menus” on
	Local address table		page 54
$JE	NAT Configuration		Enable or disable unit NAT configuration.
			Enable/Disable NAT, overloading (NAPT) per network interface.
$JF	NAT Dynamic entries		Displays current global IP addresses allocated through NAT.
$K	DHCP configuration		Enable/Disable DHCP relay and configure DHCP relay server IP address	135
	Table D-2 Menu-0A - Interface configuration
Parameter		Parameter—Options ; Definition
UNIT		In-band monitoring
		Enables or disables in-band monitoring.
		Traffic Type
		Set WAN protocol to PPP or Frame Relay.
		The selected WAN protocol applies to all WAN interfaces. In PPP mode all the TUI
		menus will be configured for PPP operations. In Frame Relay mode all the TUI menus
		will be configured for Frame Relay or Multilink Frame Relay operations.
		Multilink Protocol
		• Select Yes to enable multilink PPP (MLPPP) or multilink Frame Relay (MFR)
		according to the selected traffic type set above. Both T1/E1 links will be bonded as a
		single virtual connection and will be identified as bundle0.
		• Select No to enable independent E1 links. The two E1 links will be identified as
		NET1 and NET2.
COMM		IP Address
		Set the COMM port IP Address in standard IP form (nnn.nnn.nnn.nnn).
		Len
		Set the IP mask

Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 931 2233 113