Black Box LRU4240 manual Ospf abr-type, Ospf authentication-key, Ospf cost, Sales 0870 90 10

Dual Trunk E1 Router

ospfd(config)# router ospf 100 ospfd(config-router)# opaque-lsa-capable

Related commands

ospf abr-type

Use the ospf abr-type command to set an OSPF area border router (ABR) type.

Use the no parameter to disable this function.

Command Syntax

ospf abr-type ciscoibmshortcutstandard (no) ospf abr-type ciscoibmshortcut

cisco Specifies an alternative ABR using Cisco implementation. ibm Specifies an alternative ABR using IBM implementation. shortcut Specifies a shortcut ABR.

standard Specifies a standard behavior ABR that conforms to RFC 2328 (Default).

Command Mode

Router mode

Usage

Specify the ABR type for better functioning between different implementations. This command is specially useful in a multivendor environment.

Examples

ospfd# configure terminal ospfd(config)# router ospf 100 ospfd(config-router)# ospf abr-type standard

Related Commands

ospf authentication-key

Use the ospf authentication-key command to assign a password to be used by neighboring routers.

Use the no parameter to remove a previously assigned password.

Command Syntax

ospf authentication-key AUTHKEY no ospf authentication-key

AUTHKEY Specifies the authentication password. Any continuous string of characters (not more than 8 bytes)

Default

Authentication password not specified.

Command Mode

Interface mode

Usage

The authentication-key command creates a key (password) which is inserted into the OSPF header, when ZebOS software originates routing protocols packets. You can assign a separate password to each network for different interfaces.

All neighboring routers on the same network must have the same password to enable exchange of OSPF information. The password can be used only if authentication has been enabled for an area. Use the area authentication command to enable authentication.

Simple password authentication allows a password to be configured per area. Configure the routers in the same routing domain with the same password.

Examples

ospf authentication-key mykeykey ospf authentication-key

Related Commands

ip ospf authentication-key, area authentication

ospf cost

Use the ospf cost command to explicitly specify the cost of sending a packet on an interface.

Use the no form of this command to reset the cost of the path to default.

180 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide