Dual Trunk E1 Router

Table E-2 Router CLI Help

Topic

Description

Parameter expansion

For the area virtual-linkcommand, the AREAADDRESSID

 

parameter is replaced by either an IP address or a number in the given range:

 

AREAADDRESSID=A.B.C.D<0-4294967295>

 

The minimum command then is:

 

area 1.1.1.1 virtual-link 2.2.2.2

 

The parameters in the string (AUTHENTICATEMSGDINTERVAL) are

 

optional. Each one of which is replaced by more keywords and values.

 

 

CLI Command Modes

The commands available are divided in three categores (Unit, Kernel, and Routing) and arranged in a hierarchy. Each of the three modes has its own set of commands and its own sub modes of hierarchy.

The commands available for each routing protocol (RIP and OSPF) are separated into several modes and arranged in a hierarchy. Enable is the default mode and is the lowest level. Each mode has its own special commands; in some modes, commands from a lower level are available..

 

 

Table E-3 CLI command modes

 

 

 

 

 

 

 

 

Mode

Description

 

 

 

 

 

 

 

Enable

This mode is the base mode from where users can perform basic commands like show, exit,

 

 

quit, help, list, enable. This mode also includes some debugging command, the save

 

 

commands (for saving and viewing the configuration), show protocol specific information,

 

 

and so on.

 

 

 

 

Enable is the default mode.

 

 

 

 

 

 

 

Configure

Sometimes referred to as Configure Terminal, this mode serves as a gateway into the Interface

 

 

and Router.

 

 

 

 

 

 

 

Interface

This mode makes protocol-specific configuration commands accessible.

 

 

 

 

 

 

router

Sometimes referred to as configure-router mode, this mode

available for the RIP and OSPF

 

 

protocols, makes available router and routing commands.

 

 

 

 

 

 

 

Line

Used for access-class commands. It is available for the OSPF and RIP protocols.

 

 

 

 

 

Route-map

Mode used to set route metric, route-length and cost data. It is available for the OSPF and RIP

 

 

protocols.

 

 

 

 

 

 

 

 

When you enter the CLI, the following prompt is displayed:

 

 

Access Router CLI, type

 

 

 

 

Unit to enter Unit mode

 

 

 

 

Kernel to enter kernel mode

 

 

 

 

Rip to enter RIP mode

 

 

 

 

Ospf to enter OSPF mode

 

 

 

 

Quit to exit

 

 

 

 

[Unit/Kernel/Rip/Bgp/Ospf]:

 

 

140

SALES: 0870 90 10 750

Dual Trunk E1 Router User’s Guide

Page 152
Image 152
Black Box LRU4240 manual CLI Command Modes, Mode Description, Ospf to enter Ospf mode, Sales 0870 90 10