Black Box LRU4240 manual Configuring WAN Protocol, Configuring Single Link PPP Interface

Procedure

Set router traffic type to PPP

Set WAN port 1 IP address

Dual Trunk E1 Router

	Table 4-6 Timeslot allocation procedures
Procedure	Steps
Disabling timeslots	Example: setting timelost 1 through 8 to Idle
	1.Set allocation type to Contiguous
	2.Select Idle in Allocate by Port
	3.Enter starting Idle timeslot
	4.Enter ending Idle timeslot
Allocating alternate timeslots	Example: timeslot 7 through 17 for data
	1.Set allocation type to Alternate
	2.Select FRAC01 in Allocate by Port
	3.Enter 7 in starting timeslot
	4.Enter 17 for end timelot
	FRAC01 TS07 TS17 384 Kb/S appears in the Allocate by port fiel and
	timeslots 7, 9, 11, 13, 15, and 17 are allocated to Ethernet port, while all
	other timeslots are set automatically to idle.
Allocating timeslots manually	To manually allocate timeslots, move to the timeslot and specify the port.
	You must the other timeslots to Idle.
	Example: setting timeslots 3,7,9,14, and 15 to Ethernet port.
	1.Set allocation type to Manual
	2.Select timeslot 1 and set it to Idle
	3.Repeat step 2 to configure the other timeslots to Idle

CONFIGURING WAN PROTOCOL

The WAN protocol can be configured to Frame Relay, Multilink Frame Relay, PPP, or MLPPP.

Configuring Single Link PPP Interface

Table 4-7 Single PPP Link Configuration

Steps

1.Set Menu-0A- Traffic type field to PPP.

2.Set Menu-0A Multilink Protocol field to No. This disable multilink operation

1.Set Menu-0A NET IP address and subnet mask

Notice the menus will be configured for PPP operations. The bottom menu will display “6-PPP Cfg”.

38 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide