Dual Trunk E1 Router

login

Use this command to set a password prompt, before entering the configuration mode and to enable password checking.

Command Syntax (no) login

Default

Enabled.

Command Mode

Line mode

Usage

Login is enabled by default. The no login command allows users to connect directly to the Priviledged Exec mode skipping the password verification prompt. After using the no login command if the user changes to login command again, the system uses the password being used earlier, unless the user specifies a password in the configure mode (see the following example).

Example

The following examples show the use of login and no login command. In this example, a password pass is set (in configure mode) before using the login command.

!

ospfd# configure terminal ospfd(config)# line vty ospfd(config-line)# no login

!

!

ospfd# configure terminal ospfd#(config)# password pass ospfd#(config)# line vty ospfd#(config-line)# login

!

Related Commands

match interface

Use the match interface command to define the interface match criterion. Use the no form of this command to remove the specified match criterion.

Command Syntax match interface IFNAME no match interface

IFNAME A string that specifies the interface for matching.

Default

Disabled

Command Mode

Route-map mode

Usage

To set the conditions for redistributing routes from one routing protocol to another, use the match and set route-map configuration commands. The match commands specify the match criteria under which redistribution is allowed for the current route-map. The set commands specify the set redistribution actions to be performed, if the match criteria are met.

If a route does not match the criteria completely, it will not be advertised for outbound route-maps and neither be accepted for inbound route-maps. You can modify the data by configuring a second route-map section with an explicit match specified. Use the match interface command to match the first hop interface of a route.

Example

ospfd# configure terminal

ospfd(config)# route-map mymap1 permit 10 ospfd(config-route-map)# match interface eth0

Related Commands

match tag, match route-type external

176

SALES: 0870 90 10 750

Dual Trunk E1 Router User’s Guide

Page 188
Image 188
Black Box LRU4240 manual Login, Command Syntax no login Default, Match interface, Sales 0870 90 10