Black Box LRU4240 Description, Command Syntax description Line, Distribute-list, Sales 0870 90 10

Dual Trunk E1 Router

protocol to use the same metric value for all redistributed routes. Use this command in conjunction with the redistribute command.

Examples

ospfd# configure terminal ospfd(config)# router ospf 100 ospfd(config-router)# default-metric 100

Related commands

redistribute

description

Use the description command to add a description to an interface. Use the no form of this command to remove the description.

Command Syntax description LINE

no description

LINE 1-1023 characters that are a description of the ZebOS interface.

Command Mode

Interface mode

Usage

Examples

ospfd# configure terminal ospfd(config)# interface eth0

ospfd(config-if)# description This interface is ethernet interface

Related Commands

distance

Use the distance command to define OSPF route administrative distances based on route type.

Use the no form of this command to restore the default value.

Command Syntax

distance <1-255>ROUTEPARAMETER no distance ospf

<1-255> = OSPF administrative distance.

ROUTEPARAMETER= ospf ROUTE1ROUTE2ROUTE3 DISTANCE

ROUTE1= external Sets the distance for routes from other routing domains, learned by redistribution. ROUTE2= inter-area Sets the distance for all routes from one area to another area.

ROUTE3= intra-area Sets the distance for all routes within an area. DISTANCE= <1-255> Distance for external, intra-area, or inter-area routes.

Note: Include ROUTE1, ROUTE2 and ROUTE3 parameters one time each in a single command in any order.

Default

The default distance for each type of route (intra, inter or external) is 110.

Command Mode

Router mode

Usage

The administrative distance rates the trustworthiness of a routing information source. The distance could be any integer from 0 to

255.A higher distance value indicates a lower trust rating. For example, an administrative distance of 255 indicates that the routing information source cannot be trusted and should be ignored.

Use this command to set the distance for an entire group of routes, rather than a specific route that passes an access list.

Examples

ospfd# configure terminal ospfd(config)# router ospf 100

ospfd(config-router)# distance ospf inter-area 20 intra-area 10 external 40

Related Commands

distribute-list

170 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide