Black Box LRU4240 manual Monitor Options, Terminal User Interface Mode, To Stop a Test

Dual Trunk E1 Router

•LOOP PAYLOAD

•LOOPUP REMOTE

•TEST PATTERN

•LOOPDOWN REMOTE

•LAMP TEST

4.Press ENTER To select the test. Press ENTER again to run the test. Follow the display prompts to complete the test.

To Stop a Test

If you want to stop a running test, simultaneously press both the DOWN ARROW key and the UP ARROW key on your front panel.

The Monitor Options

The Monitor category provides a means of quickly monitoring the status of your network from the alphanumeric display. While many of the Monitor options are read only, counters can be cleared and reset to zero.

To reach the Monitor options:

1.Press the UP Arrow button to move among the categories until the Monitor category appears on the display.

2.Press the ENTER button to enter Monitor mode.

UNIT STATUS appears on the display.

3.Press either the UP or DOWN Arrow to move through the monitoring options. The Monitor options are in Table 3-4.

Table 3-4 Monitor Options

Monitor Option	Write Access
UNIT STATUS	Provides timing status. Read only.
NET STATUS	Loss of Signal (LOS), Loss of Frame (LOF),
	NORMAL. Read only.
PPP STATUS	Provide status of the PPP link.
MLPPP STATUS	Provide status of the Multilink PPP link.
ETHERNET STATUS	Provide status of the Ethernet interface.

TERMINAL USER INTERFACE MODE

The front panel display provides miminal setup, configuration and verification menus. To fully configure your LRU4240 router you will need to access the Terminal User Interface (TUI) directly through the COMM port, or Telnet via the Ethernet port or the WAN ports.

Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 25