Black Box LRU4240 manual Neighbor, Network, Passive-interface, Route

Dual Trunk E1 Router

neighbor

Use the neighbor command to specify a neighbor router. It is used for each connected point-to-point link. Use the no parameter to disable the specific router.

Command Syntax (no) neighbor A.B.C.D

A.B.C.D is an IP address of a neighboring router with which the routing information will be exchanged. Command Mode: configuration mode

Examples neighbor 1.1.1.

network

Use the network command to specify a network as one that runs Routing Information Protocol (RIP). Use the no parameter to remove the specified network as one that runs RIP.

Command Syntax

(no) network [A.B.C.D(/M)]IFNAME

A.B.C.D(/M) - specifies the IP address prefix and length of this IP network. IFNAME - alphanumeric string specifies the interface name.

Command Mode: Router Configuration Examples

network 10.0.0.0/8 network eth0

passive-interface

Use the passive-interfacecommand to enable suppression of routing updates on an interface.

Use the no form of this command to disable this function

Command Syntax

(no) passive-interface IFNAME IFNAME - specifies the interface name. Command Mode: Router Configuration

Examples passive-interface eth0

route

Use the route command to configure static RIP routes.

Use the no form of the command to disable this function.

Command Syntax

(no) route A.B.C.D/M

A.B.C.D(/M) - specifies the IP address prefix and length Command Mode: Router Configuration

Examples

route 1.2.3.4/8

Usage

router rip

...

version 1

network 10.10.10.0/24 network 10.10.11.0/24 neighbor 10.10.10.10...

ripd(config-router)# route 10.10.10.0/24...

version 1

network 10.10.10.0/24 network 10.10.11.0/24 route 10.10.10.0/24

158 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide