Black Box LRU4240 Ip route vlan-id, Ip route vlan-priority, Ip static-route clear, Multilink

Dual Trunk E1 Router

ip route vlan-id

Use the ip route vlan-idto set the unit management VLAN ID. With the default VLAN ID disabled, set to 9999, the unit will check every VLAN frame for management traffic by matching the destination IP address with the unit IP address, which is the Ethernet port IP address. By setting a unit VLAN ID, the unit will first match VLAN ID in VLAN frames, then match the destination IP address with the unit IP address. This limits management traffic to a specific VLAN and reduces the processor load. Command Syntax:

ip route vlan-id <0-4093>

Set the VLAN ID for management traffic. Command Mode: Config

Example

ip route vlan-priority

Use the ip route vlan-priorityto set the unit VLAN priority field so that it can be managed in VLAN bridging mode. Management traffic is identified with unit VLAN ID and destination MAC address.

Command Syntax:

ip route vlan-priority <0-7>

Set the VLAN Priority field. Command Mode: Config Example

ip static-route clear

Use the ip static-route clear to clear the static routing table. Command Syntax:

ip static-route clear Command Mode: Config

multilink

Use the multilink command to enable multilink PPP or multilink Frame Relay and configure the multilink protocol parameters. Command Syntax:

multilink [yes no yes ]

multilink mfr

Use the multilink mfr command to configure multilink Frame Relay protocol parameters.

Command Syntax:

link-ack [1-10] link-integrity-timer [1-180] retry-counter [1-5]

multilink mlppp

Use the multilink mlppp command to configure multilink PPP protocol parameters.

Command Syntax:

keep-alive-timeout [1-10] keep-alive-timer [1-180] retry-counter [1-5]

t1 framing

Use the t1 framing command to configure the network T1 framing format.

Command Syntax: t1 framing [net1 net2] [esf d4]

Command Mode: Config

Example

unit(config)#t1 framing net1 esf

148 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide