Black Box LRU4240 manual T1 lbo, T1 timeslot, Time-sync, Time-zone, Traffic monitoring

Dual Trunk E1 Router

unit(config)#

t1 lbo

Use the t1 lbo command to to set the Line Build Out (LBO) value to be used for tuning the circuit attenuation between the unit and the last repeater on the T1 circuit.

Command Syntax: t1 lbo [0dB -7.5dB -15 dB]

Command Mode: Config

Example

t1 timeslot

Use the t1 timeslot command to allocate an T1 timeslot and assign it to data, voice or idle. Command Syntax: t1 timeslot <1-23> [aux f1 idle]

<1-31> select an E1 timeslot number

aux	Assign selected timeslot to auxiliary dro-and-insert port
f1	Assign selected timeslot to Ethernet data port
idle	Selected timeslot will not be used

Command Mode: Config

Example

Assign timeslot 10 to transport data from Ethernet data port. unit(config)#e1 timeslot 10 f1

time-sync

Use the time-synccommand to configure the RFC-868 time protocol client. Command Syntax:

time-sync [enabled disabled] Enable of disables time synchronization. time-sync attempt-count [1-30]

time-sync attempt-interval [1-10] time-sync frequency days [0-99] time-sync frequency hours [0-23] time-sync frequency minutes [0-59] time-sync frequency seconds [0-59] time sync primary-ip A.B.C.D time-sync secondary-ip A.B.C.D time-sync port [enet net comm]

time-zone

Use the time-zonecommand to configure the GMT time zone. Command Syntax:

time-zone ahead-gmt [yes no]

time-zone day-light-savings [enabled disabled] time-zone day-light-savings diff-minutes [0-59] time-zone day-light-savings start-month [0-12] time-zone day-light-savings start-week [0-5] time-zone offset-gmt minutes [0-59] time-zone day-light-savings diff-hours [0-12] time-zone offset-gmt hours [0-12]

traffic monitoring

Use the traffic monitoring command to enable or disable RMON1 and RMON2 traffic monitoring. Command Syntax:

traffic monitoring [enabled disabled]

Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 149