Dual Trunk E1 Router

unit modem

Use the unit monitor-jackcommand to set the monitor jack to net 1 or net2. Command Syntax:

unit modem str1 WORD unit modem str2 WORD

unit outage

Use the unit outage command is reserved to configure outage source event.

unit protect-mode

Use the unit protect-modecommand to enable or disable changes from front panel. Command Syntax:

unit protect-mode [enabled disabled]

unit radius

Use the unit radius command to configure RADIUS client. Command Syntax:

unit radius [primary-server secondary-server] ip A.B.C.D unit radius [retries response-time] [1-3]

unit radius group-id WORD unit radius protocol [yes no]

unit remote-comm

Use the unit remote-commcommand to set the remote communication protocol. Command Syntax:

unit remote-comm [none att ansi]

unit sla

Use the unit sla command to configure Frame Relay SLA parameters. Command Syntax:

unit sla [enabled disabled]

unit sla [fdr-ddr-sample-period delay-period] [1-255] unit sla [fdr ddr] threshold WORD

unit sla delay-packet-size [50-1500]

unit snmp

Use the unit snmp command to configure the SNMP community strings and the three Network Management unit. Command Syntax:

unit snmp community [get } set trap] LINE unit snmp trap [1 2 3] A.B.C.D

unit snmp trap port [1 2 3 ] [comm net1 net2 bundle0 enet]

unit yellow-alarm

Use the unit yellow-alarmcommand to enable or disable yellow alarm Command Syntax:

unit yellow-alarm [enabled disabled]

wan-port in-service

Use the wan-portcommand to enable or disable service on the NET1 and NET2 WAN ports. Command Syntax:

want-port in-service [port1 port2] [yes no]

Dual Trunk E1 Router User’s Guide

TECHNICAL: 0118 96 56 000

151

Page 163
Image 163
Black Box LRU4240 manual Unit modem, Unit outage, Unit protect-mode, Unit radius, Unit remote-comm, Unit sla, Unit snmp