Black Box LRU4240 manual Interface enet, Interface frame-relay dlci, Interface frame-relay lmi

Dual Trunk E1 Router

<A.B.C.D> IP address in standard form

<Len> The subnet mask 1 to 32, the part of the IP address shared by all devices on the network. Command Mode: Config

interface enet

Use the interface enet command to set ethernet port parameters including mask length, half or full duplex mode, and promiscuous mode

Command Syntax:

interface enet bcast-mask <1-32>

Set the mask length for Net directed IP broadcast in Fast Forwading mode. Usage: Use this command in IP Fast Forwarding mode only.

interface enet data-mode [full-duplex half-duplex] Set physical data mode to half or full-duplex.

interface enet fwd-multicast [disabled enabled]

Enable or disable forwarding of multicast packets in IP Fast Forwarding mode. Usage: This command is applicable in Fast Forwarding mode only.

interface enet promiscuous [disabled enabled]

To enable or disable promiscuous mode in Bridging mode. Usage: Use this command in Bridging mode only.

interface enet proxy-arp [disabled enabled]

To enable or disable proxy-arp in Fast-forwarding mode. Usage: Use this command in Fast Forwarding mode only.

interface frame-relay dlci

Use the interface frame-relay dlci clear command to enter the DLCI number for a virtual cirtuit idendifier and the network port on which this DLCI is connected.

Command Syntax: interface frame-relay dlci <16-1023> [net 1 net2 bundle0] <16-1023> dlci range

net1, net2, or bundle 0 Network interface on which the DCLI is connected Command Mode: Config

Example

Unit(config)#interface frame-relay dlci 20 net1

interface frame-relay lmi

Use the interface frame-relay lmi command to enable or disable LMI and configure LMI parameters.

Command Syntax: interface frame-relay lmi [disabled enabled enquiry-rx-timer enquiry-tx-timer full-status-count max-lmi- errir type unit-location]

	disabled	Disable LMI Conditioning
	enabled	Enable LMI Conditioning
	enquiry-rx-timer	<5-30>	Set the expected interval in 5 seconds increments between expected receive enquiry status
	enquiry-tx-timer	message
		<5-30>	Set the interval in 5 seconds increments between the sending of a STATUS ENQUIRY and the
	full-status-count	receipt of a response.
		<5-30> Set the interval in 5 seconds increments between the sending of a STATUS ENQUIRY and the
	max-lmi-error	receipt of a response.
		<5-30>	Set the interval in 5 seconds increments between the sending of a STATUS ENQUIRY and the
	unit-location	receipt of a response.
		[CPE CO]
	Command Mode: Config
144	SALES: 0870 90 10 750			Dual Trunk E1 Router User’s Guide