56
PRO SWITCHING SYSTEM
To Enter the IP Address into the Rack
1. Connect a VT100 terminal to the AUX port (located at the rear of the unit).
Use a null-modem-type cable or equivalent. Refer to Table 5-5.

Table 5-5. AUXPort Pin Assignments

Pin # Signal
1 Chassis GND
2 TXD
3 RXD
4 RTS
5 CTS
6 NOT USED
7 Signal GND
8 NOT USED
9 NOT USED
2. Set the communication settings of the VT100 terminal. Refer to Table 5-6.

Table 5-6. VT100 Terminal Communication Settings

Bits per second 9600
Data bits 8
Parity None
Stop bits 1
3. Assign an IP address to the Pro Switching System by entering the following
into the terminal:
SET RACK n IP ADDRESS a.b.c.d
where:
nis the rack address (set by the user via DIP-switch-group DS4), and
a.b.c.d is the IPaddress.
Example:
SET RACK 1 IP ADDRESS