59
CHAPTER 5: Installation
Make sure to choose “SNMPover TCP/IP Communications” when the screen
offering this selection appears.
Upgrade to C2.17:
1. When the installation ends, return to your Windows 95 desktop and click on
Start, Run…The Run screen appears.
2. Enter the following: E:\OV217\Setup (if necessary, replace E:\ with the
correct letter of the CD-ROMdrive). Upgrading begins. Follow all installation
instructions that appear on your screen.
3. When the installation is complete, restart your computer before running HP
OpenView.
NOTE
After installing the software, you MUST restart your computer before
running HPOpenView.
5.3.3 I
NSTALL
SNMP A
PPLICATION
S
OFTWARE
1. Insert Disk 1 into your disk drive.
2. From your Windows 95 desktop, click on Start, Run… The Run screen
appears.
3. Enter the following: A:\Setup. Installation begins. Follow all installation
instructions that appear on your screen.
4. When the installation is complete, restart your computer before running the
application software.
NOTE
After installing the software, you MUST restart your computer before
running the application software.
5.4 System Configuration
Once you enter the IPaddress into the unit, the network manager can access and
continue configuring the rack remotely through the 10BASE-T connector via
Telnet sessions.
To properly operate your Pro Switching System from your system management
center, you must configure your system with the correct information.