61
CHAPTER 5: Installation
To Configure Rack Settings
Enter… In order to…
SET RACK n FACTORY DEFAULTS
Clear the battery-backed-up configuration and set all
SNMP/Telnet parameters and MIB variables to their default
values:
DEFAULT ROUTER set to 0.0.0.0
IP ADDRESS set to 0.0.0.0
SNMP MANAGER are all cleared
SNMP READ COMMUNITY NAME set to “public”
SNMP SECURITY TRAPS set to 10
SNMP TRAPS set to ON
SNMP WRITE COMMUNITY NAME set to “private”
SUBNET MASK set to 0.0.0.0
TELNET IDLE TIMEOUT set to 60 minutes
TELNET PASSWORD set to NONE
TELNET SECURITY TRAPS set to 3
SET RACK n DEFAULT ROUTER x.x.x.x
Set the default router to where packets will be sent if their
destination IP address is not on the same network. If the default
router is not set, a proxy ARP server is required for these
packets to reach their destination. Default value: 0.0 0.0
SET RACK n DIGITAL1|ANALOG|DIGITAL2
DISCONNECT|BRIDGE|BREAKDCE|BREAKDTE LINE x
Perform switching operations. This is not a configuration setting.
Entering this command connects the bus of rack n to line x. You
must specify n and x. Enter only one selection from DIGITAL,
ANALOG, or DIGITAL2. Enter only one selection from
DISCONNECT, BRIDGE, BREAKDCE, or BREAKDTE.