Installation 
Oven Assembly
OVEN ASSEMBLY TO STAND
Single Section
1.Place the assembled stand in the location where the oven is going to be used.
2.Remove the side control compartment cover and open the front control panel of a single oven (or lower section).
3.With a tool, punch out the
4.Set the oven on the stand. Center it to the frame.
5.Align the front, and rear bolt holes of the oven with the bolt holes in the stand.
6.Insert a bolt and washer, from the top down through each of the 2 holes.
7.Place a nut and washer on each of the 2 bolts, and tighten securely.
8.Replace the oven’s side control compartment, and close the front control panel.
NOTE: For single section ovens only. For double stacked ovens step 8 will be completed once the ovens are stacked.
Double Section
1.Assemble the lower section to the stand as de- scribed. DO NOT replace the side control compartment or close the front control panel.
2.With a tool, punch out the
3.Remove the side control compartment cover and open the front control panel of the upper oven.
4.With a tool, punch out the
5.Set the upper oven on the lower oven.
6.Align the front, and rear bolt holes of the upper oven with the bolt holes in the bottom oven.
7.Insert a bolt and washer, from the top down through each of the 2 holes.
8.Place a nut and washer on each of the 2 bolts, and tighten securely.
9.Replace the control compartment cover, and close the front control panel on both of the ovens.
Figure 5
Figure 4
7
