Installation
Stand Assembly
Open Stands With Racks
1.Lay stand frame top down on the floor as shown. See Figure 3.
2.Position the four leg assemblies and support angles as shown. Attach with the
NOTE: Be sure the support angles and clips are located correctly for your oven configuration. See Figure 3.
3.Position the bottom shelf between the legs so that the smooth top surface is facing the top of the stand.
4.Align the shelf holes with the bolt holes found near the bottom of each leg.
5.Insert a carriage bolt from the outside of the leg, through the leg, and through the shelf cor- ner bracket.
6.Place a lock washer and nut on each bolt, and tighten securely. See the Figure 2.
7.Repeat Steps
NOTE: Be sure the slots in the top shelf are aligned with the support angles.
8.Insert the top of the rack stops into the two back clips on the angle supports as shown. In- sert the bottom of the rack stops into the slots in the top shelf as shown.
9.Insert the rack supports into the remaining four clips on the angle supports as shown. In- sert the bottom of the rack supports into the slots in the top shelf as shown.
10.Tighten all loose bolts.
| Back of Stand |
|
| Rack Stop | Support |
|
| |
|
| Angle |
Support | Support |
|
Angle, LH |
| |
Angle, |
| |
|
| |
RH |
| Top Shelf |
| Rack | (rear) |
| Support | Rack |
|
| Support |
|
| Attach Rack Supports and Rack Stops |
Figure 3
6
