Cisco Systems OL-19025-01 manual Adding a User From an External Ldap Directory, Example johndoe

Appendix D Basic Phone Administration Steps

Adding a User to Cisco Unified Communications Manager

Adding a User From an External LDAP Directory

If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you can immediately synchronize that directory to the Cisco Unified Communications Manager on which you are adding this same user and the user’s phone by following these steps:

Procedure

Step 1 Log onto Cisco Unified Communications Manager Administration.

Step 2 Choose System > LDAP > LDAP Directory.

Step 3 Use the Find button to locate your LDAP directory.

Step 4 Click on the LDAP directory name.

Step 5 Click Perform Full Sync Now.

Note If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory window determines when the next auto-synchronization is scheduled. However, the synchronization must occur before you can associate a new user to a device.

Step 6 Proceed to “Configuring the Phone” section on page D-4.

Adding a User Directly to Cisco Unified Communications Manager

If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager Administration by following these steps:

Procedure

Step 1 Choose User Management > End User, then click Add New. The End User Configuration window appears.

Step 2 In the User Information pane of this window, enter the following:

–User ID—Enter the end user identification name. Cisco Unified Communications Manager does not permit modifying the user ID after it is created. You may use the following special characters: =, +, <, >, #, ;, \, , "", and blank spaces.

Example: johndoe

–Password and Confirm Password—Enter five or more alphanumeric or special characters for the end user password. You may use the following special characters: =, +, <, >, #, ;, \, , "", and blank spaces.

–Last Name—Enter the end user last name. You may use the following special characters: =, +, <, >, #, ;, \, , "", and blank spaces.

Example: doe

–Telephone Number—Enter the primary directory number for the end user. End users can have multiple lines on their phones.

Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)

OL-19025-01 D-3