Cisco Systems OL-19025-01 manual Configuring Startup Network Settings, Hold Mute Speaker

Chapter 3 Setting Up the Cisco Unified IP Phone

Configuring Startup Network Settings

Table 3-2	LED Diagnostic Status
Hardware Test		MWI	Hold	Mute	Speaker
Power is Ready		On	On	On	On
Flash is Accessible		—	On	On	On
RAM Test Successful		—	—	On	On
Ethernet Test Successful		—	—	—	On

2.The screen displays the Cisco Systems, Inc., logo screen.

3.These messages appear as the phone starts up.

–Configuring IP message

–Registering

4.The home screen displays:

–Current date and time

–Primary directory number

–Additional directory numbers and speed dial numbers, if configured (Only on Cisco Unified IP Phone 6961)

–Softkeys

If the phone successfully passes through these stages, it has started up properly. If the phone does not start up properly, see the “Resolving Startup Problems” section on page 9-1.

Configuring Startup Network Settings

If you are not using DHCP in your network, you must configure these network settings on the

Cisco Unified IP Phone after installing the phone on the network:

•IP address

•IP subnet information

•TFTP server IP address

•You also may configure the domain name and the DNS server settings, if necessary.

Collect this information and see the instructions in Chapter 4, “Configuring Settings on the Cisco Unified IP Phone.”

	Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
OL-19025-01		3-13