Cisco Systems SCE 2000 4xGBE manual To cable the External Optical Bypass module

Appendix A The External Optical Bypass Module

Installing the External Bypass Module

The following figure illustrates the connectivity of the External Optical Bypass module.

To cable the External Optical Bypass module:

Step 1 Connect an optical cable (user supplied) between the GBE port on the Subscriber side network element and the SUB port on the External Optical Bypass module.

Step 2 Connect an optical cable (user supplied) between the GBE port on the Network side network element and the NET port on the External Optical Bypass module.

Verify that the links between the two network elements are active.

Step 3 Connect the SUB cable of the fiber of the External Optical Bypass module to the SUB GBE port of the SCE 2000 platform.

Rx <-> Tx

Step 4 Connect the NET cable of the fiber of the External Optical Bypass module to the NET GBE port of the SCE 2000 platform.

Rx <-> Tx

Step 5 Power up the SCE 2000 platform, as explained in Starting the System and Observing Initial Conditions (on page 7-2).

Warning Auto-Negotiation should be configured identically for the two SCE 2000 platform GBE interfaces and the GBE interfaces of the switch/router on either side of the External Optical Bypass module.

It is recommended that the two GBE interfaces of the SCE 2000 platform, as well as the GBE interfaces of the switch/router on either side of the External Optical Bypass module, be configured to Auto-

Negotiation = OFF

Verify that the relevant GBE interfaces of the SCE 2000 platform are now in sync, as the External Optical

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 A-7