Cisco Systems SCE 2000 4xGBE manual Performing Initial System Configuration, 5-26, C H A P T E R

C H A P T E R 5

Connecting the Management Interfaces and

Performing Initial System Configuration

This chapter explains how to connect the SCE 2000 platform to a local console and perform the initial system configuration via the setup wizard that runs automatically.

Additionally, this chapter contains instructions for cabling the Fast Ethernet Management interface.

Note When installing a cascaded system, it is extremely important to follow the sequence of procedures outlined in the section Installing a Cascaded System (on page 6-12).

This chapter contains the following sections:

•	Connecting the Local Console	5-1
•	Initial System Configuration	5-3
•	Connecting the Management Interface		5-26

Connecting the Local Console

Even if you will be managing the SCE 2000 from a remote location, you must first connect the unit to a local console and configure the initial settings for the SCE 2000 to support remote management. When the initial connection is established, the setup utility will run automatically, prompting you to perform the initial system configuration.

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 5-1