Cisco Systems SCE 2000 4xGBE manual Type the default domain name to be used, and press Enter

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Initial System Configuration

Enable IP DNS-based hostname translation? [yes]:

If you choose to disable DNS lookup, skip the rest of this section and go to Step 6: Configuring the RDR Formatter Destination (on page 5-12). The rest of the dialog is not presented, as it is irrelevant when DNS lookup is disabled.

Step 3 Type the default domain name to be used, and press Enter.

Note that there is no default domain name.

You may accept the default domain name or enter a new one.

Enter default domain name []:

Step 4 Type the IP address of the primary domain name server and press Enter.

Enter Primary DNS IP address:

Note that there is no default for this parameter.

Step 5 You may configure up to three domain servers.

Would you like to add another Name Server? [no]:

•To exit the DNS settings dialog, press Enter.

•To add another domain server, type y and press Enter.

You are asked to enter the IP address of the next domain name server.

Enter Secondary DNS IP address:

Step 6 When IP addresses for all servers have been entered, exit the dialog by pressing Enter.

Would you like to add another Name Server? [no]:

EXAMPLE:

Following is a sample DNS configuration dialog. The default domain name is pcube.com, and the IP address of the Domain Name Server is 10.1.1.230.

Would you like to enter the DNS configuration menu? [no]: y

Enable IP DNS-based hostname translation? [yes]:

Enter default domain name []: pcube.com

Enter Primary DNS IP address: 10.1.1.230

Would you like to add another Name Server? [no]:

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 5-11