Cisco Systems SCE 2000 4xGBE manual Quantity, Description, Connect This Port To…, LED Groups

Chapter 2 Overview of the SCE 2000 Platform

Front Panel

Table 2-2	SCE 2000 Ports
Port	Quantity	Description	Connect This Port To…
Mng1/	2	10/100/1000 Ethernet RJ-45 ports for	A LAN using an FE cable
Mng2		management of the SCE 2000.	with an RJ-45 connector
		Mng 2 is currently not operational.
		CLI designation: 0/0.
Console	1	RS-232 RJ-45 port for use by	A local terminal (console)
		technicians	using an RS-232 cable with
			an RJ-45 connector, as

provided in the SCE 2000 kit.

AUX	1	RS-232 RJ-45 port used by technicians
GBE ports 1-	4	GigabitEthernet SC ports for connecting
4		to the line and/or cascading two devices

CLI designation: 0/1 through 0/4

Refer to Connecting the Line Ports (Connecting the Line Ports "Connecting the line ports to the network" on page 6-1) for cabling diagrams for various topologies

Table 2-3	SCE 2000 LED Groups
LED Groups	Description
Power A	• Continuous green: Power supply A is functioning normally
	• Red: Power supply A present, but malfunctioning
	• Unlit: Power supply A is either not present or has failed.
Power B	• Continuous green: Power supply B is functioning normally
	• Red: Power supply B present, but malfunctioning
	• Unlit: Power supply B is either not present or has failed.
Status	The Status LED indicates the operational status of the SCE 2000 system, as
	follows:
	• Unlit: indicates no power from either power unit.
	• Orange: indicates that the system is booting up.
	• Flashing green: indicates that the system is fully operational.
	• Flashing orange: indicates that the system is operational, but is in a warning
	state.
	• Red: indicates that there is a problem or failure
	Note that Alarms are hierarchical: Failure takes precedence over Warning, which
	takes precedence over operational.

SCE 2000 4xGBE Installation and Configuration Guide

2-4 OL-7824-02