Cisco Systems SCE 2000 4xGBE manual Configuring SNMP, Enable SNMP management? no y

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Initial System Configuration

Step 8: Configuring SNMP

Managing the SCE 2000 is possible also via a Network Management System (NMS) that supports SNMP. By default, SNMP is disabled on the SCE 2000.

To enable SNMP management you must configure the following basic SNMP parameters:

•SNMP traps status and managers.

•Community strings (where an SNMP community string is a text string that acts like a password to permit access to the SNMP agent on the SCE 2000).

To configure SNMP parameters, complete the following steps:

Step 1 Enter the SNMP configuration menu.

Would you like to enter the SNMP configuration menu? [no]: y

Type y and press Enter.

The SNMP configuration dialog begins.

Step 2 Enable SNMP management.

Type y and press Enter.

Enable SNMP management? [no]: y

If you choose to disable SNMP management, skip the rest of this section and go to Step 9: Configuring the Topology-Dependent Parameters. The rest of the dialog is not presented, as it is irrelevant when SNMP management is disabled.

Step 3 Type the SNMP GET community name and press Enter.

The SNMP agent that resides inside the SCE 2000 will respond only to GET requests that use this community string.

Enter SNMP GET community name:

Note that there is no default for this parameter.

Step 4 Assign an access list to restrict the SNMP management stations that may use this GET community.

Type a number (1 through 99) or type “0” to permit access to all IP addresses, and press Enter.

Enter Access list number allowing access with this community string, use ‘0’ to allow all:

Step 5 The maximum number of GET communities is 20.

•To add more entries, type y and press Enter

•Would you like to add another SNMP GET community? [no]:y

Enter up to 20 SNMP GET communities as described in step 3 and step 4.

•When all entries have been added, press Enter

Would you like to add another SNMP GET community? [no]:

Step 6 Type the SNMP SET community name and press Enter.

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 5-17