Cisco Systems SCE 2000 4xGBE manual Connecting the Management Interface

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Connecting the Management Interface

EXAMPLE #2:

Following is an example of a configuration that was applied and saved to the startup configuration as well as to an FTP site.

Although not demonstrated in this example, it is recommended that you always view the configuration before applying it.

Data collection for				the system	configuration	is completed.
Would	you	like	to view the new		configuration	before it is applied? [yes/no]:
Apply	and	Save	this	configuration? [yes/no]:		y

(New configuration would be displayed here)

The running configuration would be overwritten by the changes you have just entered, are you sure? [yes/no]:y

The new running configuration will be saved to the startup configuration. Do you want to save a copy of the startup configuration file in a remote station? [no]:y

Enter a full FTP path of the remote destination: ftp://vk:vk@10.1.1.253/h:/copyofstartup.txt

Committing configuration...

Configuration completed successfully.

Saving configuration...

Writing general configuration file to temporary location...

Backing-up general configuration file...

Copy temporary file to final location...

Done!

EXAMPLE #3:

Following is an example of a configuration that was aborted, although no errors were detected.

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]: Apply and Save this configuration? [yes/no]: n

The changes you have just entered would be discarded, are you sure? [yes/no]:y

Setup procedure aborted, no configuration changes made.

Connecting the Management Interface

The procedures for cabling the management port and testing connectivity between the SCE 2000 and the remote management host are explained in the following sections:

•Cabling the Management Port (on page 5-27)

•Verifying Management Interface Connectivity (on page 5-28)

Note By default, the management port is configured to auto-negotiation enabled. To change this default setting, refer to Configuring the Management Interface Speed and Duplex Parameters.

SCE 2000 4xGBE Installation and Configuration Guide

5-26 OL-7824-02