Cisco Systems SCE 2000 4xGBE Reconnecting the Power, Reconnecting AC-Input Power Supply Unit

Chapter 4 Installation and Maintenance

Removing and Replacing a Power Supply Unit

Note The power supply is not fully seated until you tighten the installation screw on the faceplate.

This completes the procedures for replacing a power supply in a SCE 2000 platform.

Reconnecting the Power

The following sections describe how to reconnect the AC or DC power:

•Reconnecting AC-Input Power Supply Unit (on page 4-22)

•Reconnecting DC-Input Power Supply Unit (on page 4-23)

Reconnecting AC-Input Power Supply Unit

The following procedures explain how to reconnect an AC-input power to the SCE 2000 platform.

If you are reconnecting DC-input power, proceed to Reconnecting DC-Input Power Supply Unit (on page 4-23).

To reconnect the AC-input power to the SCE 2000 platform, complete the following steps:

Step 1 Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply

Figure 4-14: Connecting the AC Power

SCE 2000 4xGBE Installation and Configuration Guide

4-22 OL-7824-02