Cisco Systems SCE 2000 4xGBE manual Cabling the Management Port

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Connecting the Management Interface

Cabling the Management Port

The SCE 2000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port. The Mng 2 port is currently not operational.

To cable the management port, complete the following steps:

Step 1 Take the Ethernet cable provided (with attached RJ-45 connector) and plug it into the Mng 1 port on the front panel of the SCE 2000, as shown in the following figure.

Figure 5-2: Cabling the Management Port

Step 2 Connect the other end of the Ethernet cable into your management network.

Make sure that you push on the RJ-45 connector attached to the cable until you hear a click, which indicates that the connector is fully inserted and secured in the receptacle. Gently pull on the plug to confirm whether the plug is locked into the socket.

If the Link LED on the SCE 2000 management port does not light, try removing the cable and reinserting it firmly into the module socket. To disconnect the plug from the socket, press down on the raised portion on top of the plug, releasing the latch. You should hear an audible click indicating the latch has released.

Carefully pull the plug out of the socket.

If the management port Link LED on the SCE 2000 still does not light, verify that the cable is connected correctly to the appropriate network element on its second end.

T

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 5-27