Cisco Systems SCE 2000 4xGBE manual The following example displays a system response

Chapter 6 Cabling the Line Ports and Completing the Installation

Connecting the line ports to the network

EXAMPLE:

The following example displays a system response.

SCE 2000#show interface GigabitEthernet 0/1

Auto negotiation configured: Enabled

Actual Status:

Link is on

Auto negotiation: Enabled

Bandwidth: 100000Kbps

Burst-size: 50000bytes

Auto-negotiation for bump-in-the-wire topology may be enabled or disabled. For receive-only topologies, using an external splitter, auto-negotiation must be disabled.

To view the Gigabit Ethernet counters, complete the following steps:

Step 1 At the SCE 2000# prompt, type show interface GigabitEthernet 0/interface- number counters.

This displays the GigabitEthernet counters. This command enables you to verify that traffic is taking place. You can see that the counters increase, together with the increased number of packets that flow through the SCE 2000.

Again, in bump-in-the-wire topology, both the Rx and Tx counters apply as traffic monitors. For receive- only topologies, using an external splitter, only the Rx counters apply.

EXAMPLE:

The following example shows the counters of the first Gigabit Ethernet interface.

SCE 2000#show interface GigabitEthernet 0/1 counters

In total octets: 100

In good unicast packets: 90

In good multicast packets: 0

In good broadcast packets: 10

In packets discarded: 0

In packets with CRC/Alignment error: 0

In undersized packets: 0

In oversized packets: 0

Out total octets: 93*2^32+1022342538

Out unicast packets: 858086051

Out non unicast packets: 0

Out packets discarded: 0

You are now ready to continue to the next stage, loading and activating an SCE application.

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 6-11