Cisco Systems SCE 2000 4xGBE SCE 2000 Operational Status, Description, Status LED State, Booting

Chapter 8 Troubleshooting

Troubleshooting Overview

SCE 2000 Operational Status

The following table lists the operational states of the SCE 2000. The Status LED on the SCE 2000 Front Panel reflects the current SCE 2000 operational status. The operational status can be displayed using CLI command show system operation-status.

Table 8-2	SCE 2000 Operational States
SCE 2000		Description	Status LED State
Operational
Status
Booting		Initial state after reset	Orange
Operational		SCE 2000 becomes operational after completing the following	Flashing green
		process:
		• Boot is completed
		• Power self-tests are completed without failure
		• Platform configuration is applied
Warning		SCE 2000 is fully operational (as above) but one of the	Flashing orange
		following occurred:
		• Line ports (GBE ports) to the link are down
		• Management port link is down
		• Temperature raised above threshold
		• Voltage not in required range
		• Fans problem
		• Power supply problem
		• Insufficient space on the disk
		Note: If the condition that caused the SCE 2000 to be in
		Warning state is resolved (for example, link is up) the SCE
		2000 reverts to Operational state.
Failure		System is in Failure state after Boot due to one of the following	Red
		conditions:
		• Power on test failure.
		• Three abnormal reboots in less than 20 minutes
		• Platform configured to enter Failure mode consequent to
		failure-induced reboot (this is configurable using CLI
		command).
		Note: Depending on the cause of failure, the management
		interface and the platform configuration may or may not be
		active/available.

SCE 2000 4xGBE Installation and Configuration Guide

8-8 OL-7824-02