Cisco Systems SCE 2000 4xGBE manual Configuring the GBE Interface Parameters

Chapter 6 Cabling the Line Ports and Completing the Installation

Connecting the line ports to the network

Configuring the GBE Interface Parameters

By default, the SCE 2000 GBE line interface ports are configured with auto-negotiation disabled. The procedure for enabling auto-negotiation for the GBE line interface ports is explained in the following section.

Note

Note

Auto-negotiation must be disabled when the SCE 2000 is deployed via an external optical splitter (receive-only topology)

.

If you change any parameters, you must save the new configuration settings. Type copy running-configstartup-config, and press Enter

Configuring GigabitEthernet Auto-Negotiation

To configure GBE auto-negotiation for a specified GBE port interface, complete the following steps:

Step 1 To enter the Global Configuration Mode, at the SCE 2000# prompt, type configure, and press Enter.

The SCE 2000(config)# prompt appears.

Step 2 To enter the desired GBE port interface, type interface GigabitEthernet 0/portnumber, and press Enter, where portnumber is the number of the selected port (1-4).

The SCE 2000(config if)# prompt appears.

Step 3 Type auto-negotiate and press Enter.

The SCE 2000(config if)# prompt appears.

Step 4 To return to Global Configuration Mode, type exit and press Enter.

The SCE 2000(config)# prompt appears.

Repeat this procedure to configure auto-negotiation for the other GBE port interfaces as needed.

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 6-7