iDP3221 User’s Manual
(2)The maximum printable size of a bitmap image is 512 by 512 dots for standard mode. In page mode, the size can be extended up to 831 bits in the y direction (paper feed direction) if 831 bits are reserved for y of the print area and the value of print direction "n" specified by ESC T is 1 or 3.
Mapping of print data in the print area
Print data is mapped in the print area as follows:
(1)The print area is set by ESCW. When the printer has finished all of the print and paper feed actions specified before receiving an ESC W, the ESC W sets the left end (as viewed facing the printer) as the start point (x0, y0) of the print area. The print area is a rectangle defined by two edges extending from the start point (x0, y0): one edge running in the x (horizontal) direction by dx pitch (inclusive of the start point), and the other running in the y (vertical) direction by dy pitch. (If no ESC W is defined, the default values are used to define the print area.)
(2)With a print area defined by ESC W and a print direction specified by ESC T, when the printer receives print data, the print data is mapped in the print area where point A (see the figure "Mapping Position for Character Data") is used as the initial value of the start point. If the print data consists of characters, this start point serves as the baseline.
If the print data is a downloaded bitmap image or a bar code, the print data is mapped with its
(3)If print data (or the space to the right of a character) extends beyond the print area before command that involves a line feed (for example, LF or ESC J command) is received, a line feed is automatically executed, so that the mapping position of the print data is moved one line. The next mapping position will be the beginning of the line. In this case, the line feed width is as defined by a command such as ESC 2 or ESC 3.
(4)By default, the line feed width is 1/6 inch, which is equivalent to 30 dots. If the print data for the next line includes a vertically doubled character or taller, a downloaded bitmap image extending two or more lines, or a bar code taller than the character height, the data, therefore, falls short of the line feed width, causing the upper dots of the character to overlap the print data of the current line. The line feed width needs to be increased.
In the following example the line feed width for the first line should equal at least 27 dots (see the figure "Mapping Position for a Downloaded Bitmap Image").
121 | CITIZEN |
