
iDP3221 User’s Manual
ESC | FF |
|
[Function] | Printing data in Page mode | |
[Code] |
| <1B>H<0C>H |
[Outline] | Executes a batch printout of the data mapped in every print area in Page mode. | |
[Caution] | • This command is only effective when Page mode is selected. |
•Mapped data, as well as the ESC T and ESC W settings, and the character mapping position are held even after printing.
[See Also] | "Page Mode" in Appendix 1 |
| FF, ESC L, ESC S |
ESC | SP | n |
|
|
[Function] | Setting the right spacing of the character |
| ||
[Code] |
| <1B> H <20> H <n> |
| |
[Range] | 0 ≤ n ≤ 32 |
| ||
[Outline] | Sets the right spacing of character to [n ⋅ basic calculation pitch] inches. | |||
[Caution] | • If the horizontal magnification of character is 2 or more, the right spacing increases with | |||
|
| the magnification. |
| |
|
| • This command does not affect kanji characters. | ||
|
| • The right spacing can be set separately for the Standard and Page modes. | ||
|
| • The basic calculation pitch is set by GS P. | Once defined, the right spacing is not changed | |
|
| if the basic calculation pitch is changed by GS P. | ||
|
| • Fractions resulting from calculation are | corrected with the minimum pitch of the | |
|
| mechanism, and the remainder is omitted. |
| |
|
| • In Standard mode, this command uses the horizontal basic calculation pitch (x). | ||
|
| • In Page mode, the basic calculation pitch used by this command depends on the start point: | ||
|
| (1) | If the start point specified by ESC T is top left or bottom right, the command uses the | |
|
|
| horizontal basic calculation pitch (x). |
|
|
| (2) | If the start point specified by ESC T is top right or bottom left, the command uses the | |
|
|
| vertical basic calculation pitch (y). |
|
|
| • The maximum settable right spacing is approximately 35.983 mm (255/180 inches). A | ||
|
| setting greater than this maximum is trimmed to the maximum. | ||
[Default] | n = 0 |
|
| |
[See Also] | GS P |
|
|
47 | CITIZEN |