iDP3221 User’s Manual
GS | $ | nL | nH | |
[Function] |
| Specifying the absolute vertical position of characters in Page mode | ||
[Code] |
| <1D>H<24>H<nL><nH> | ||
[Range] |
| 0 ≤ nL ≤ 255 | ||
|
|
| 0 ≤ nH ≤ 255 | |
[Outline] |
| This command is used in Page mode to specify the vertical position of characters at the data | ||
|
|
| mapping start position as an absolute value measured from the start point. The vertical | |
|
|
| position of a character at the next data mapping start position will be at a distance of [(nL + | |
|
|
| nH ( 256) ( basic calculation pitch] inches away from the start point. | |
[Caution] |
| • This command is ignored when Page mode is not selected. | ||
|
|
| • Any specification of absolute vertical position out of the printable area is ignored. | |
|
|
| • The horizontal position of a character at the data mapping start position is not moved. | |
|
|
| • The start point used as the reference is specified by ESC T. | |
|
|
| • Depending on the start point specified by ESC T, this command acts as follows: | |
|
|
| (1) | If the start point is the top left or bottom right, the command specifies the absolute |
|
|
|
| position in the paper feed direction (the character's |
|
|
|
| vertical basic calculation pitch (y). |
|
|
| (2) | If the start point is the top right or bottom left, the command specifies the absolute |
|
|
|
| position in the direction perpendicular to the paper feed (the character's |
|
|
|
| direction) using the horizontal basic calculation pitch (x). |
|
|
| • The basic calculation pitch is set by GS P. | |
|
|
| • Fractions resulting from calculations are corrected with the minimum pitch of the | |
|
|
| mechanism, and the remainder is omitted. | |
[See Also] |
| ESC $, ESC T, ESC W, ESC ¥, GS P, GS ¥ | ||
83 | CITIZEN |
