Conair GB/ WSB Fast, This key, will, allow, to exceed the, normal blending rate, of your unit

NOTE: Fractional cycles are not blended. Total weight may be in over the target by as much as one cycle weight.

The EXIT key will exit the BTCH sequence at any point but will NOT cause the system to start a new batch.

If an additional 120 volt output is desired for an alarm, substitute a 4 or 7 for the 00001. 4 turns on the Additive outlet, 7 turns on component 7 output.

If you have a printer connected, totals will print automatically. (see VIEW, * for details).

FAST:	This key	will	allow		you	to exceed the	normal blending rate
	of your unit.		Once		your system has learned proper flow
	rates of	each	material,			the timing of	each component
	dispense	is very consistent cycle to cycle. The FAST key
	allows one or		more	FAST		REPEAT cycles	to follow a normal
	calibrated cycle.			In a		FAST REPEAT cycle all components are
	dispensed simultaneously, without any						weights being taken.
	Errors in dispense amounts will not be detected. These are,
	in fact,	volumetric			dispenses, not gravimetric. These
	dispenses take much				less time. Throughput may be doubled in
	this manner.

This key is NOT FUNCTIONAL unless the 4th digit of the "FLG" parameter is set to 1 (xxx1x). To do this, see the SOFTWARE MAINTENANCE section, PARAMETER TABLE, "FLG".

The shorter mixing time may be a problem. So the number of FAST REPEAT cycles is kept as low as possible. Up to 4 repeats may occur.

After pressing the FAST key, use the * key to toggle the FAST flag ON of OFF. When set to (FAST OFF) FAST mode will not operate. When set (FAST ON) every normal calibrated dispense will be followed by up to 4 FAST repeat dispenses.

Press * to toggle between (FAST ON) and (FAST OFF).

Press EXIT, to exit.

When the FAST mode is in operation, the display ( FAST) will flash intermittently.

TAG:	This key (third row,	third key)	allows three pieces of
	information to be "tagged" onto		all data that is	either
	printed or retrieved	through the computer port.		The items
	are WORK ORDER, OPERATOR, and RECIPE number.

This key is NOT FUNCTIONAL unless the 2nd digit of the "FLG" parameter is set to 1 (x1xxx). To do this, see the SOFTWARE MAINTENANCE section, PARAMETER TABLE, "FLG".

Press once to display the current Work Order number (WO-----). Press again to display the current Operator

number (OPRTR---). Press again for the Recipe (RECP ---). You may enter or change the Work Order or Operator number when each is displayed. Recipe number can not be altered.

Page 30