Page 5 | + | ||
| |||
¦ | PART I | - ASSEMBLY | ¦ |
| + | ||
ASSEMBLY | and INSTALLATION INSTRUCTIONS |
| |
CAUTION: | LOAD CELLS ARE EASILY DAMAGED. |
| |
If the FRAME is dropped from TWO | FEET, the load cells WILL be DAMAGED. | ||
| PLEASE, | BE CAREFUL. |
|
The following items have been shipped to you:
1.FRAME, fully assembled: (bolted to pallet)
2.CONTROLLER: the controller and the instruction manual.
3.FEEDERS: optional COLOR or ADDITIVE feeders as ordered.
4.FLOW CONTROL ASSEMBLY: optional
5.FLOOR STAND or VACUUM TAKEOFF ASSEMBLY: optional
RED INSTRUCTION STICKERS will assist you during assembly.
LIFT HANGERS are available to allow lifting of the blender with a strap or chain. Call us if you require them.
1A. If your | unit | is | to be MACHINE mounted: |
|
For GB/WSB | 100, 200, and 400 series | models: | ||
Two | ways | to | do this are suggested | ON THE NEXT PAGE. |
The LEFT diagram shows the FRAME and SLIDE GATE both drilled with the proper bolt pattern for your machine and THROUGH- BOLTED to your press.
The RIGHT diagram shows only the 10 x 10 steel
For GB/WSB 900 and 1800 series models:
An additional machine mount adaptor plate may be required. If you have ANY DOUBT about the STABILITY of the unit when bolted directly to your machine throat, please call us for advice.
NOTE: When choosing proper orientation, be sure you have access to the controller and weigh chamber, clearance for hinged doors, and access to removable feeder hoppers.
1B. If your unit | is STAND | mounted: |
|
|
A stand is | provided | and your | unit will bolt directly | to it. |
An assembly DIAGRAM | is provided if stand assembly is | required. |
An air operated FLOW CONTROL ASSEMBLY is provided for dispensing into a container. The purpose of this unit is to allow time for mixing to occur after each dispense. This flow valve keeps the mix chamber full to just below the sensor. This assembly bolts directly to the bottom of the Blender frame.
Page 8