Conair GB/ WSB PARAMETERS: Press the PARA key to display the, table, of operating, Para, There

A new setting may be entered at this time by keypad if so desired. (CE will cancel entry before last digit is entered.) Settings entered by keypad CAN NOT BE ALTERED by the thumbwheel switches. After entering a setting by keypad, verify this by rotating the appropriate thumbwheel switches. An LED will light indicating that the internal setting being used by the computer does not match the thumbwheel switches.

The display of a setting followed by pressing the "CE" key, will revert that setting back to thumbwheel control and will also exit the sequence. EXIT will exit the sequence.

This function will positively fix the settings so that thumbwheel switches have no control and no one can change them without authorization. An LED will light indicating this override condition. The LED will be lit ONLY when the thumbwheel setting does not match the internal setting.

To allow the operator the ability to stop running this component, a setting of all ZEROS (00.0) is still accepted as valid and will override any setting that has been entered by keypad. If you do not want this override option, enter a 1 as the first digit in the SE parameter. See PARAMETERS, _SE.

To later return to thumbwheel control, use the same procedure as above except instead of entering a setting, press the "CE" key when you see the setting displayed.

PARAMETERS: Press the PARA key to display the		table	of operating
(PARA)	parameters that reside in memory.	There	are more then 60
	parameters, and each successive press of		the key displays
	the next parameter in the table. Pressing			the "*" key
	allows you to back-up in the table. You		may change a
	parameter by entering a new number	over the old one. CE
	will cancel a number entry before the last			digit is entered.
	All parameters are fully explained	several		pages forward in
	this manual. EXIT will exit the sequence.

STAR FUNCTIONS.

*02 This flag for EXTRUSION and YIELD control.

Press (*,0,2) to turn on		Extrusion	or Yield control.
The default display is	(	OFF).
Press * to toggle this	flag to (		RATE ), (EXT CTRL), or
(YLD CTRL).

If you are using our EXTRUSION or YIELD control software to control your extruder, refer to our EXTRUSION CONTROL instruction booklet for complete information.

If you simply want to view throughput continuously on			the
blender display, set this	option to (	RATE ). This	will
Page	35