Conair GB/ WSB manual Save, Btch, Table, Flg

Press RCP		to	look at		another recipe. Display = (GET			__).
Enter 2	digits to retrieve					one of 99 recipes.
Display	will		flash through			the current stored data:
(RCP	__), (R =			xx	), (C	= xx.x), (A = xx.x), (*TO LOAD)
Press *	to LOAD this				recipe into memory.
Routine will exit					automatically.
Press RCP		or	EXIT to		return to the display (GET		__).
Press RCP		or	EXIT again to			exit.
To SAVE	a	RECIPE		you	must be in the PROGRAM mode.
If you press			RCP	key	again	after display of (GET		__),
display	says		(SAVE		__).	Enter 2 digits, display will say
(SAVING		).	The	current settings are saved into memory
under the		recipe		number you have entered. These are
normally the			THUMBWHEEL switch settings.

CAUTION: If settings have been entered by KEYPAD or RECIPE, then these are the ones that will be saved. Therefore, when saving a recipe, be certain that no other recipe is currently loaded, and that no keypad-entered settings are currently loaded. The lower right corner of 3 LEDs should be off indicating thumbwheels are being read.

To clear a stored recipe, set all thumbwheel switches to zero and enter these zero settings into the recipe location.

Routine will EXIT automatically.

EXIT will exit at any time.

When a RECIPE is loaded, three LEDs, (R, C, A, Locked out) light indicating that the thumbwheel settings do not represent the settings that are being run by the controller. Whenever internally stored settings are not the same as the thumbwheel settings, these three LEDs light to indicate this condition. These LEDs correspond to REGRIND, COLOR, and ADDITIVE settings respectively.

NOTE: To allow the operator the ability to stop running any single component, a thumbwheel setting of all ZEROS (00.0) can be accepted as valid to override any setting entered by a Recipe. If you want this override option, enter a 0 (_SE 0xxxx) as the first digit in the SE parameter. The default entry of 1 (_SE 1xxxx) indicates the override option is turned off. See PARAMETERS; SE.

BATCH:	This key allows you to blend a PRE-SELECTED	WEIGHT of
(BTCH)	material, and then STOP running and sound the ALARM.		The
	process may also be programmed to sound the	alarm but
	continue running. Since each cycle will always blend		a full
	weigh bin amount, the total amount blended may exceed		the
	target batch weight by up to one cycle's blend weight.
	This key is NOT FUNCTIONAL unless the last digit of the
	"FLG" parameter is set to 1 or 2 (xxxx1). To do this, see
	the SOFTWARE MAINTENANCE section, PARAMETER	TABLE, "FLG".
	The ALARM SILENCE button on the side of the	controller, is
	Page 28