For extremely, Fluffy, Very heavy, Material, Reset, If the

TH 01000 The highest and lowest acceptable TARE weights for

TL 00500 blend cycle to start. (full or tenth grams)

TL prevents starting with the weigh bin out of place. No change is required.

TH prevents starting with a full weigh bin. Change TH only if clumps of material hang up in the weigh bin.

PRT 00000 MINUTE interval between automatic print of TOTALS.

This parameter will cause your system to PRINT MATERIAL TOTALS automatically. A printer must be connected.

RSE 01000	Upper SETTING limits for thumbwheels (0xxx.x).
CSE 01000	Settings greater than limit are held to limit.
ASE 01000	"01000" = 100%.
RLO 00050	Lower SETTING limit for REGRIND (0xxx.x).
_SE	parameters SET UPPER LIMITS to the thumbwheels. For color
	and additive, lower settings may help ensure expensive
	material is not wasted.
RLO	sets a LOW limit of 5 percent to the REGRIND setting.
DLY 00488	Delay before cycle start. (interrupts)

This parameter is the time that the sensor must be uncovered before a cycle will begin.

LT1 00000 Loader #1 time. (seconds)

These are timers for loaders. Since loader outputs are not yet available, leave them set to zero.

RPT 00000 Percent of target to reduce first try dispense. NPT 00000

APT 00000

These can increase the accuracy of slow dispense devices ONLY, like augers, and micro pulse valves.

RWT 26000	WT/TI = the rate that will	be used for calculating the
RTI 00976	next dispense time.
NWT 26000	WT = the Weight portion of	the dispense rate, calculated
NTI 00976	such that WT/TI equals the average of the last two
CWT 10240	actual dispense rates.
CTI 31232	TI = the TIME portion of the dispense rate. (interrupts)
AWT 10240
ATI 31232
These change AUTOMATICALLY during		normal operation.
They are Weight and Time portions		of the flow rate calibration.

Page 46