Configuring Switch Information 301
Port VLAN Mode
— Indicates the port mode. Possible values are:
General
— The port belongs to VLANs, and each VLAN is user-defined as tagged or untagged
(full 802.1Q mode).
Access
— The port belongs to a single untagged VLAN. When a port is in Access mode, the
packet types which are accepted on the port (packet type) cannot be designated. It is also not
possible to enable/disable ingress filtering on an access port.
Trunk
— The port belongs to VLANs in which all ports are tagged (except for an optional
single native VLAN).
PVID (1-4063, 4095)
— Assigns a VLAN ID to untagged packets. The possible values are 1-4063
and 4095. VLAN 4095 is defined as per standard and industry practice as the discard VLAN;
packets classified to this VLAN are dropped.
Frame Type
— Frame type accepted on the port. Possible values are:
Admit Tag Only
—Indicates that only tagged frames are accepted on the port.
Admit All
—Indicates that both tagged and untagged frames are accepted on the port.
Ingress Filtering
— Enables or disables Ingress filtering on the port. Ingress filtering discards
frames where the VLAN tag does not match any port VLAN.
Assigning Port Settings
1
Open the
VLAN Port Settings
page.
2
Select the port to which you want to assign settings from the
Port
drop-down menu.
3
Complete the remaining fields on the page and click
Apply Changes
.
The VLAN port settings are defined, and the device is updated.
Displaying the VLAN Port Table
1
Open the
VLAN Port Settings
page.
2
Click
Show All
to display the
VLAN Port Table
.
NOTE: If an Access port is chosen, the packet types that are accepted on the port (packet type) cannot
be designated. It is also not possible to enable or disable ingress filtering on an access port.
Assigning Ports to VLAN Groups Using CLI Commands
The following table contains the CLI commands for assigning ports to VLAN groups.