132 Configuring System Information
www.dell.com | support.dell.com
Configuring Out-of-Band RADIUS Servers
The
OOB RADIUS Settings
page contains both user-defined and the default RADIUS settings for
the Out-of-Band management port. For more information on RADIUS servers, see "Configuring
TACACS+ Settings."
To open the
OOB RADIUS Settings
page, click
System
→
Out-of-Band Port
→
RADIUS
in the tree
view (see OOB RADIUS Settings, Figure 6-19).
Figure 6-19. OOB RADIUS Settings
The
OOB RADIUS Settings
page contains the following fields:
IP Address
—The Authentication Out-of-Band port IP address.
Priority (0-65535)
—The Out-of-Band port priority. The possible values are 0-65535.
Authentication Port
—The authentication port, which is used to verify the RADIUS server
authentication.
Number of Retries (1-10)
—Number of transmitted requests sent to the RADIUS server before a
failure occurs. The possible field values are 1-10. The default value is 3. If no host-specific value is
specified, the global value applies to each host.
Timeout for Reply (1-30)
—Amount of time in seconds the device waits for an answer from the
RADIUS server before timing out. The possible field values are 1-30. The default value is 3. If no
host-specific value is specified, the global value applies to each host.
Dead Time (0-2000)
—Amount of time (in minutes) that a RADIUS server is bypassed for service
requests. The range is 0-2000. If no host-specific value is specified, the global value applies to each
host.