Configuring System Information 121
Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Broadcast Interface Table
.
NOTE: When defining Anycast or Broadcast interfaces, at least one IP address must be defined.
The following is an example of the CLI commands for configuring SNTP interfaces:
Table 6-8. SNTP interface Settings CLI Commands
CLI Command Description
sntp client enable E
nables the Simple Network Time Protocol
(SNTP) broadcast and anycast client on an
interface.
show sntp
configuration Displays the SNTP configuration.
Console (config)# interface ethernet g1
Console (config-if)# sntp client enable
Console (config-if)# end
Console# show sntp configuration
Polling interval: 7200 seconds.
MD5 Authentication keys: 8, 9
Authentication is required for synchronization.
Trusted Keys: 8,9
Unicast Clients Polling: Enabled.
Server Polling Encryption Key
----------- -------- -----------------
176.1.1.8 Enabled 9
176.1.8.179 Disabled Disabled
Broadcast Clients: Enabled
Broadcast Clients Poll: Enabled
Broadcast Interfaces: g1