Configuring System Information 157
Enabling ARP Proxy Using CLI Commands
The following table contains the CLI commands for enabling the ARP Proxy.
The following is an example of the CLI commands:
Console (config)# ip proxy-arp
Defining ARP Settings
Use the
ARP Settings
page to define ARP parameters for an IP interface. The ARP table is used to
maintain a correlation between each MAC address and its corresponding IP address. The ARP table
can be filled in statically by the user. When a static ARP entry is defined, a permanent entry is put
in the table, which the system uses to translate IP addresses to MAC addresses.
To open the
ARP Settings
page, click
System
→
IP Addressing
→
ARP
in the tree view.
Figure 6-35. ARP Settings
Table 6-23. ARP Proxy CLI Commands
CLI Command Description
ip proxy-arp Enables ARP proxy
no ip proxy-arp Disables ARP proxy