Configuring Switch Information 269
4
Click
Apply Changes
.
The new port mirroring session is enabled for the port, and the device is updated.
Modifying a Port Mirroring Session
1
Open the
Port Mirroring
page.
2
Modify the fields.
3
Click
Apply Changes
.
The port mirroring session fields are modified, and the device is updated.
Deleting a Port Mirroring Session
1
Open the
Port Mirroring
page.
2
Check the
Remove
check box.
3
Click
Apply Changes
.
The port mirroring session is deleted, and the device is updated.
Configuring a Port Mirroring Session Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring a Port Mirroring
session as displayed in the
Port Mirroring
.
The following is an example of the CLI commands:
Console(config-if)# port monitor g2
Configuring Address Tables
MAC addresses are stored in either the static address or the dynamic address database. Static
addresses are defined by the user. Dynamic addresses are learned by the system, and are erased after
a time-out. A packet addressed to a destination stored in one of the databases is forwarded
immediately to the ports. The static and dynamic address tables can be sorted by interface, VLAN,
and interface type. In addition, addresses can be added to the static and dynamic address tables.
To open the
Address Tables
page, click
Switch
→
Address Table
in the tree view.
Table 7-11. Port Mirroring CLI Commands
CLI Command Description
port monitor
src-interface
[rx | tx] Starts a port monitoring session.
show ports monitor Displays status of port monitoring.