Dell 6024, 6024 F Enabling Telnet Access

Configuring the Switch 87
Figure 5-4. Internet Protocol (TCP/IP) Properties Window
4
Click Use the following IP address .
5 Enter the appropriate addresses for the management station in the IP address , Subnet mask ,
and
Default gateway fields.
NOTE: If the management station is connected to a router and not directly to the 6024/6024F switch, the
default gateway must be configured as the router interface IP address connected to the management
station (which leads to the 6024/6024F switch).
Enabling Telnet Access
Use the Windows/DOS command line or a Telnet application to access the device via a Telnet.
Remember to enter the appropriate password. The connection is done with the IP address defined
on the device.
When access is granted, command usage is the same as in direct device management:
1 On the management station, click Start → Run.
2 In the Run window, type cmd and click OK .
The standard Windows command line interface is displayed.