Dell 6024, 6024 F Using the CLI

56 Using Dell OpenManage Switch Administrator
www.dell.com | support.dell.com
Using the CLI
Command Mode Overview
The CLI is divided into command modes. Each command mode has a specific command set.
Entering a question mark at the console prompt displays a list of commands available for that
particular command mode.
In each mode, a specific command is used to navigate from one command mode to another.
During the CLI session initialization, the CLI mode is the User EXEC mode. Only a limited subset
of commands are available in the
User EXEC mode. This level is reserved for tasks that do not
change the console configuration and is used to access configuration sub-systems such as the CLI.
To enter the next level, the Privileged EXEC mode, a password is required (if configured).
The
Privileged EXEC mode provides access to the device global configuration. For specific global
configurations within the device, enter the next level, Global Configuration mode. A password is
not required.
The
Global Configuration mode manages the device configuration on a global level.
The Interface Configuration mode configures the device at the physical interface level. Interface
commands which require subcommands have another level called the Subinterface Configuration
mode. A password is not required.
User EXEC Mode
After logging into the device, the EXEC command mode is enabled. The user-level prompt consists
of the host name followed by the angle bracket (>). For example:
console>
NOTE: The default host name is console unless it has been modified during initial configuration.
The user EXEC commands permit connecting to remote devices, changing terminal settings on a
temporary basis, performing basic tests, and listing system information.
To list the user EXEC commands, enter a question mark at the command prompt.
Privileged EXEC Mode
Privileged access can be protected to prevent unauthorized access and ensure operating parameters.
Passwords are displayed on the screen, and are case sensitive.
To access and list the Privileged EXEC Mode commands:
1 At the prompt type enable and press <Enter>.
2 When a password prompt displays, enter the password and press <Enter>.
The Privileged EXEC mode prompt displays as the device host name followed by #. For
example:
console#